Prusa Mini XZ Short Support
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Someone asked for a shorter version. This version only sticks out 40mm from the Z support.
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 94
- Wydruki
- 1
- Wyświetlenia
- 788
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
If you don't know if you have this issue just take a look under the electronics box from the front. It was noticeable on mine that it wasn't level.
Attach to the 3030 aluminium extrusions using two M5 x 12 mm hexagon head cap screws and T nuts.
See attached Figure for what this tries to fix:
Extrusion A is used to connect the Z axis arm C. The Z axis arm is off center from the Connection point on A and has a decent amount of weight. This causes it to sag at point B. This in turn causes a change where Z axis is no longer 90deg from point A. This angle offset will translate into a difference between Z1 and Z2 between the extruder and build plate.
You should be able to print this version without supports. I added cutouts on the top of the recessed hole to enable printing.