1 / 2
Reinforced PCI / ISA Slot Bracket for IDE 40pin to SD adapter — zdjęcie 1
1 / 2

Reinforced PCI / ISA Slot Bracket for IDE 40pin to SD adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remixed from "PCI / ISA Slot Bracket for IDE 40pin to SD adapter", this adds the following enhancements: Thicker…

Ocena
5 / 5
Polubienia
16
Pobrania
412
Wydruki
3
Wyświetlenia
1988
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Remixed from "PCI / ISA Slot Bracket for IDE 40pin to SD adapter", this adds the following enhancements:

  • Thicker triangle areas along the bracket so stress from inserting/removing the SD card doesn't flex the bracket as much.
  • Enclosed bracket screw hole, no standalone small tab to break on top.
  • Longer bottom tab, which should completely clear any slot's receiver hole. Printing notes:

  • The triangle shaped brace running the length of the bracket is at a negative angle, but is less than 60 degrees and should not need support.

  • It's possible the bottom tab may be too long in certain conditions. If so, just use tin snips or similar to cut the tab down to size.
  • For mounting the IDE2SD card, I personally enlarge the printed mounting holes using a 7/64" drill bit, and screw them in with standard coarse-thread machine PC screws. It's possible to screw in without pre-drilling, but takes a lot of force.

    How I Designed This

    Tinkercad source

Category: Computer

Tagi