1 / 3
CR Touch Zero Y Offset with Inserts and more screw space.
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The original model does not use inserts, which is why I created this model.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 60
- Wydruki
- 0
- Wyświetlenia
- 395
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Most of the information about the printer setup can be found on the original model page:
https://www.printables.com/model/438224-x45-sprite-cr-touch-probe-zero-y-offset-mount-v11-
Not every hole should have a threaded insert. Only the CR Touch holder and the ribbon holder have the correct sizes. I included the step file, so feel free to adjust it to your liking.
What you need for this model:
- M3 inserts, 5.7mm x 4.6mm, mine look like this:
- A new holder for the ribbon where M3 screws fit through. I do not have M2 inserts, so I used M3 ones for the ribbon holder. The original creality holder uses M2 screws/inserts, but they will not hold. This ribbon holder works: https://www.printables.com/model/449608-sleek-sprite-extruder-ribbon-cable-strain-relief
Some Recommendations:
- First prepare the inserts, before disassembling the extruder, and check that everything works as expected.
- I had quite a bit of problems designing the holes/inserting the threaded inserts correctly, this guide might be helpful: https://hackaday.com/2019/02/28/threading-3d-printed-parts-how-to-use-heat-set-inserts/
- You can print the entire model without supports, orientation should be correct.