1 / 9
Flywoo Flylens75-85 drone with DJI O3 Air Unit - Cooling Tower — zdjęcie 1
1 / 9

Flywoo Flylens75-85 drone with DJI O3 Air Unit - Cooling Tower

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Needed a way to keep my CineWhoop drone from over-heating while connected to BetaFlight.

Ocena
5 / 5
Polubienia
10
Pobrania
49
Wydruki
1
Wyświetlenia
667
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution

This is a cooling tower I made that blows air up into and out around the DJI O3 Air Unit when you're configuring a Flywoo Flylens75-85 with the DJI O3 Air Unit.  This is so it won't over heat while connected to BetaFlight Configurator (or for any reason that you need to leave your drone on while not flying).  DJI relies on flying the drone to cool it so if it's just sitting there "ON", even if not doing anything with it, it will eventually go to low power mode and shutdown.  

I used Prusament PETG Slate Silver.

The fan is a standard USB with speed control 40x40x10 cooling fan.

I used 4 m3x6x5 threaded brass inserts and 4 m3x18 socket head screws with flat and lock washers.  I did this because I used the fan grill that came with the fan and it has holes just barely small enough for this type of screw.

I also include some grip tape cutting templates.  I used 2mm thick self-adhesive grip tape on the feet and 1mm on the top.  I used these templates to rough cut then after applying I trimmed the excess off with an X-Acto knife.

3-19-2024:  Added a version with a cable clip notch allowing the fan's cable to be “hooked” into this so the wire connection at the fan isn't being pulled on when transporting.  Included gcode file for how I printed it with supports.  The settings I used allowed me to pull the supports off in 1 big chunk even with prusament petg.

3-23-2024:  Removed air vents to promote greater air flow force onto the drone.  Increased height from bottom of inside of the tower to the top rim where the drone rests to provide more clearance between fan and drone bottom.

Tagi