1 / 2
EnXLosure Unifi G3 Instant Cam mount — zdjęcie 1
1 / 2

EnXLosure Unifi G3 Instant Cam mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

EnXLosure mount for a Unifi G3 Instant cam

Ocena
4 / 5
Polubienia
3
Pobrania
21
Wydruki
1
Wyświetlenia
245
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial

Made an EnXLosure mount for a Unifi G3 Instant cam. There's a cable channel to tuck the cable behind the mount.

Remove stock G3 Instant swivel mount, retain stock mount bolt and reuse.

Options for attaching to enclosure:

  1. Insert an M3 heatset insert into the front hole in the enclosure bottom right rail
  2. Use a longer M3 bolt to go through the original plexiglas hole and into a nut in the mount (You must remove or omit the original insert from the outside panel and use an M3 nut in the mount)

Print with the surface of right side facing down (M3 nut side pointing up), no supports needed. One warning, PrusaSlicer was being a little odd and put a floating overhang in even though the surface of the right side (when viewed in correct orientation) so I sunk the model 1 layer beneath the bed to ensure it was flat.

Parts needed:

Method 1: (1) M3 heatset insert, (1) M3 4mm bolt

Method 2: (1) M3 nut, (1) M3 >10mm bolt

Optional: Cable clips here

Tagi