Hoverboard hub motor mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed this for an etrike project and needed a mount for the 6.5" hoverboard hub motor I was using. This was printed…
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 93
- Wydruki
- 0
- Wyświetlenia
- 644
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
Designed this for an etrike project and needed a mount for the 6.5" hoverboard hub motor I was using.
This was printed at 80% infill with 2mm sidewall and top/bottom, with petg printed with side down. This might be overkill and you might be able to do a little less infill but I needed the extra strength.
This was snap fit tight over my hoverboard hub motor shaft.
Bolt holes are for 9.5mm (3/8") bolts with 9.5mm (3/8") ID x 22mm OD washers
Since its printed on its side the bolt holes were a little tight.
Print Settings
Printer Brand:
Creality
Printer:
CR-10
Rafts:
Doesn't Matter
Supports:
No
Resolution:
.2
Infill:
80%
Filament: Generic PETG
Category: Hobby