Hoverboard hub motor mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Designed this for an etrike project and needed a mount for the 6.5" hoverboard hub motor I was using. This was printed…
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 93
- Makes
- 0
- Views
- 644
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
Designed this for an etrike project and needed a mount for the 6.5" hoverboard hub motor I was using.
This was printed at 80% infill with 2mm sidewall and top/bottom, with petg printed with side down. This might be overkill and you might be able to do a little less infill but I needed the extra strength.
This was snap fit tight over my hoverboard hub motor shaft.
Bolt holes are for 9.5mm (3/8") bolts with 9.5mm (3/8") ID x 22mm OD washers
Since its printed on its side the bolt holes were a little tight.
Print Settings
Printer Brand:
Creality
Printer:
CR-10
Rafts:
Doesn't Matter
Supports:
No
Resolution:
.2
Infill:
80%
Filament: Generic PETG
Category: Hobby