Receiver and Capacitor Mount (for cinelog 35 v2)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple receiver and capacitor mount that fits onto 2.5mm spacer, has 11.5x4mm receiver mount and 10mm capacitor mount.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 57
- Wydruki
- 0
- Wyświetlenia
- 265
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
I recently was preparing my Cinelog 35 v2 for a new FC, and I was upset about the capacitor placement blocking the battery wires from reaching the pads on the board. For this reason, I took measurements of the original TPU parts from the drone, and merged them into one simple piece.
This piece can fit onto any 2.5mm spacer, at a height of 11.6mm, fits a 10mm diameter capacitor and the receiver mount is 11.5x4 mm. It also contains a wire guide above the reciever mount.
This piece should fit the stock Cinelog 35 components, and possibly other drones made by GEPRC and some others, but no guarantees.
Should print just fine with regular TPU, takes about 30 minutes to print, only about a gram of filament.