IKEA Bergshult (30cm) monitor stand legs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Extended version of the IKEA Bergshult legs to support the 30cm version of the shelf instead of the original 20cm.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 80
- Wydruki
- 0
- Wyświetlenia
- 779
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I will be using it with a 32" curved Samsung monitor so the 20cm version of the shelf would have been too shallow for the monitor's stand.
The leg ends up being 27.5cm in the long direction so you'll need a large print bed in order to print it. It took 10.5 hours per leg at 0.3mm layer, 12% triangular infill, and 4 walls on my CR-10 V3.
I pre-drilled the mounting holes and attached the legs using 1.25" wood screws.
Instead of cork strips on the bottoms, I glued on craft foam strips using a thin layer of Weldbond white glue. They prevent the riser from sliding on the desk once it's loaded but are much thinner and less noticeable than the cork strips would have been in my setup.