Glorious Model O Wireless Mouse Base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A stand for the Glorious Model O Wireless mouse
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 89
- Wydruki
- 1
- Wyświetlenia
- 1823
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
This stand provides a place to store your Glorious Model O Wireless mouse.
A hole under the sensor prevents desk vibrations from triggering the mouse (and waking your computer) and there is clearance for the charging cable.
There are four versions available:
- 2-piece, with an insert designed to be printed in TPU or another flexible filament
- 1-piece, where the entire part is solid (if you don't have or can't print TPU)
- Both 2-piece and 1-piece with straight vertical sides (if you don't prefer the sloped sides of the original)
The 2-piece version includes cutouts where you can place 1-oz wheel weights (available on everyone's favorite jungle website) to give the base a bit of heft. The 1-piece version does not have these.
Print with 0.2mm Structural preset. For the 2-piece version, I used PolyFlex 95A TPU for the insert. Note that the base has a lip that secures the insert, so the insert must be flexible. If you print the 2-piece version in non-flexible filament you won't be able to get the insert in.
Printing with MMU/XL should also be possible but was not tested, and if you pause mid print you would be able to drop the weights in as well.
I've also included a STEP of a “blank” insert which can be used to customize for other mice if you wish. Some may fit in the existing base, while some may require adjusting the size of the base as well. Feel free to remix as desired. ;)