openHASP touchscreen tactile switches
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Accessory to openHASP touchscreen that behaves as tactile switch for customized "virtual" buttons on the screen.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 416
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Introduction:
I use openHASP at several wall switch locations in my home for scene, light and appliance control via Home Assistant. I find it cumbersome to touch the 2.4 inch ILI9341 touchscreen at the correct spot, and I am sure I am not alone. I was considering re-designing my wall plates to also include mechanical switches on the side of the screen, but came up with this solution instead. It works great!
Printing:
I use PETG filament with 0.2mm layers. I switch filament colors at 4mm which is where the actual buttons begin.
Installation and Use:
This addon clips into the wall plate just between the touchscreen and the plastic plate. It acts as a tactile switch without interfering with the operation of the touch screen. When programming the openHASP screen, I generally use four horizontal buttons per page as seen in the below photo.
