1 / 3
CH Products Pro Throttle 50% detent - forward backward throttle
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
CH Products Pro Throttle 50% detent - forward backward throttle
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 166
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial
Add a detent to you CH Products Pro Throttle to turn it into a forward backward throttle.
There are 2 versions with different stiffness, pick one depending on the filament used and resistance you want. I printed mine in PETG, TPU 95A was too soft.
No supports needed.
Installation
- To install turn the throttle upside down and remove the 4 rubber feet with a flat head screw driver or similar (they are glued on with sticky tape).
- Unscrew the 4 screws under the feet with a phillips screw driver.
- Unscrew the middle screw that holds the throttle plat in place with a phillips screw driver.
- Place the new printed part as per the image and screw back in using the same screw that was removed in step 3.
- Close everything back up.
- Stick the rubber feet back on.
