QUICK-CLIP : Spring Clip / Glove Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Contents: Spring Clip / Glove Holder for QUICK-CLIP v3
- Ocena
- 5 / 5
- Polubienia
- 201
- Pobrania
- 732
- Wydruki
- 3
- Wyświetlenia
- 4336
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
NOTE: This is an add-on to the pre-existing "QUICK-CLIP : Base Starter Kit"
Post-Processing Difficulty: Easy (Ready to Use from Printer)
Tools/Items Needed: Elastic Rubber Band, Side Cutters (to trim hinge to size)
Introduction & Instructions:
QUICK-CLIP is a versatile mounting system that I designed for backpack and MOLLE webbing. This is a spring clip / glove holder module that I designed to go with the base starter set (found under my profile). It is attached to and removed from the mounting system in the same way as the other modules. The clip is tensioned using a, elastic rubber band, which can be used to adjust the clamping force by using more or less wraps around the clamp.
I printed it with 0.16mm layer lines with PLA with no supports or brims.
The two pieces are attached together using one piece of standard 1.75mm filament as a hinge.
Hope you enjoy!