Radiator fan booster (Heatbooster)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a model which uses an Heatbooster and a couple of fans to boost radiator output.
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 85
- Wydruki
- 0
- Wyświetlenia
- 1355
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This is a model which uses an Heatbooster and a couple of fans to boost radiator output.
You will need the following stuff:
- 2 Noctua NF-A6 25 pwm fans (each module takes two fans)
- A heatbooster (https://www.sdr-engineering.nl/webshop/index.php?route=product/product&product_id=50)
- A fan extension cable (when using multiple modules). For a reference check the images for an example.
- A 12v adapter to power the heatfan (the amount of Amperage depends on the amount of fans). For 4 1A will work, but for 6/8 2A is better.
The bottom model is used to hold the fans in place, the top cover is just for good looks. They will just slide into place, if they are to loose a drop of glue might help.
Orientation:
- The top part should be oriented bottom side up
- The bottom part should be printed at its default orientation
Print settings:
I printed these in PLA on my X1C, no supports needed. Margins in the mating connectors are quite tight. Thats so that they don't slide out easily. A drop of glue can be used to make it stay put if needed.
You can use other printing filaments which can better handle heat, but for me i haven't needed it.