1 / 6
Stitching Thread Organizer Remix w/ magnets, fillets, & thicker body
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rectangular stitching thread organizer remix with 20x 10mm loops for threads, central captive magnets, & more tweaks
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 39
- Wydruki
- 1
- Wyświetlenia
- 259
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (13)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (0)Kolekcje (22)Powiązane
There are two versions of this:
- The short version - final version as asked to design by my spouse
- The long version - closer to the origin model, but with some tweaks… and mistakes on magnets
Both versions were printed in PLA on a Bambu A1 Mini.
Short Version
- 77mm long by 36mm wide & 5.8mm thick
- 10x 10mm diameter loops
- 2x 8mm diameter loops at either end
- Recessed needle minder for Number 9 needles (45mm)
- uses 7x 6x2 neodymium magnets
- Pause between 11/12 to glue in magnets; then resume printing
Long Version
- 155mm long by 46mm wide & 4.8mm thick
- Keeps original design but thicker, adds fillets, and…
- Magnetic Needle Minder - NOT recessed
- This is kind of broken, as I didn't account for material shrinkage
- Intended to fit a double-stack of 6x2 magnets - but only enough space for one magnet per hole
- Pause between 11/12 to glue in magnets; then resume printing
- Also included are alternate versions with or without magnets/fillets
- F3D file is just built off of IE's upload (as of March, 2024)
Printed in PLA on a Bambu A1 Mini with these settings…
- 3-4 walls/shells - I prefer 4
- 20% or higher infill (gyroid)
Good to print in lighter or at least BRIGHT colors. With white filaments, I find it helps to sand down the print after. Don't have that same issue with other colors.