1 / 6
Stitching Thread Organizer Remix w/ magnets, fillets, & thicker body
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Rectangular stitching thread organizer remix with 20x 10mm loops for threads, central captive magnets, & more tweaks
- Rating
- 5 / 5
- Likes
- 14
- Downloads
- 39
- Makes
- 1
- Views
- 259
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial
There are two versions of this:
- The short version - final version as asked to design by my spouse
- The long version - closer to the origin model, but with some tweaks… and mistakes on magnets
Both versions were printed in PLA on a Bambu A1 Mini.
Short Version
- 77mm long by 36mm wide & 5.8mm thick
- 10x 10mm diameter loops
- 2x 8mm diameter loops at either end
- Recessed needle minder for Number 9 needles (45mm)
- uses 7x 6x2 neodymium magnets
- Pause between 11/12 to glue in magnets; then resume printing
Long Version
- 155mm long by 46mm wide & 4.8mm thick
- Keeps original design but thicker, adds fillets, and…
- Magnetic Needle Minder - NOT recessed
- This is kind of broken, as I didn't account for material shrinkage
- Intended to fit a double-stack of 6x2 magnets - but only enough space for one magnet per hole
- Pause between 11/12 to glue in magnets; then resume printing
- Also included are alternate versions with or without magnets/fillets
- F3D file is just built off of IE's upload (as of March, 2024)
Printed in PLA on a Bambu A1 Mini with these settings…
- 3-4 walls/shells - I prefer 4
- 20% or higher infill (gyroid)
Good to print in lighter or at least BRIGHT colors. With white filaments, I find it helps to sand down the print after. Don't have that same issue with other colors.