1 / 11
Animatronic Tail Gen 1.0 V2
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a finished version of the Tail Gen 1
- Ocena
- 0 / 5
- Polubienia
- 34
- Pobrania
- 81
- Wydruki
- 0
- Wyświetlenia
- 864
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (11)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (0)Kolekcje (52)Powiązane
This is a finished version of the Tail Gen 1
How to assemble?
What you'll need:
- Some sort of thick multi-core wire (for the core). Something similar to “Stainless-Galvanized-Aircraft-Balusters-Handrail”
Note: Use a vinyl-coated wire, It will make your life much easier.
The wire should be 5mm thick (about 0,20 inches) and should be 83 cm (about 32,6 inches) long.
- Pulling wire(s). I used a 3mm (about 0,12inch) thick multi-core flexible wire, tho I can't find any similar wires now. You'll need two of them and they should be around 120 cm (about 47,2 inches) long but this is my estimate so take this with a grain of salt.
- Servos. You'll need two of them, and make sure that they're strong and they have metal teeth, I accidentally annihilated one (now, four of them) of my servos because it was too weak. I reccomend using some stron servos like 60kg ones.
- RPI Pico.
- 4M screws.
Use the F3d File as your guide on how to assemble this.
Category: Fashion