1 / 3
HAL PCG 6500 Case
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for my HAL PCG 6500 reproduction programmable Character generator for the Commodore CBM PET Series.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 210
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Additional Material needed
- HAL PCG 6500 - for obvious reasons ;)
- my Hal 6500 reproduction project:
https://github.com/InsaneDruid/PCG-6500
- my Hal 6500 reproduction project:
- 4mm*5.7mm M3 threaded heat set inserts depending on printed version:
- 16x (2piece bottom version)
- 8x (1piece bottom)
- M3 hex nuts
- 8x (2piece top case)
- 0x (1piece top case)
- M3 bolts
- 24x (2piece version)
- 8x (1piece version)
Further Notes
- Print all parts standing upright.
- The parts are wide and quite tall so they are prone to warping, even with PLA. I had one even lifting the magnetic sheet off the print bed. So a little sanding might be needed on the top shell.
- Still, printing them upright gives the best strength and very smooth, round corners.
- Should print better with fully enclosed printers.
- For bigger printers, single piece versions are included.