1 / 3
HAL PCG 6500 Case
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Case for my HAL PCG 6500 reproduction programmable Character generator for the Commodore CBM PET Series.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 22
- Makes
- 0
- Views
- 210
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Additional Material needed
- HAL PCG 6500 - for obvious reasons ;)
- my Hal 6500 reproduction project:
https://github.com/InsaneDruid/PCG-6500
- my Hal 6500 reproduction project:
- 4mm*5.7mm M3 threaded heat set inserts depending on printed version:
- 16x (2piece bottom version)
- 8x (1piece bottom)
- M3 hex nuts
- 8x (2piece top case)
- 0x (1piece top case)
- M3 bolts
- 24x (2piece version)
- 8x (1piece version)
Further Notes
- Print all parts standing upright.
- The parts are wide and quite tall so they are prone to warping, even with PLA. I had one even lifting the magnetic sheet off the print bed. So a little sanding might be needed on the top shell.
- Still, printing them upright gives the best strength and very smooth, round corners.
- Should print better with fully enclosed printers.
- For bigger printers, single piece versions are included.