1 / 6
45 Degree Bed/45&90 Degree Buddy Box Cables Prusa MK3.5 MK3.9 MK4 for Enclosure — zdjęcie 1
1 / 6

45 Degree Bed/45&90 Degree Buddy Box Cables Prusa MK3.5 MK3.9 MK4 for Enclosure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

No pinch, not fret, bed cable re-routing. 45 (ish) degree bed cable routing for enclosure. 45 & 90 degree for Buddy box

Ocena
0 / 5
Polubienia
15
Pobrania
98
Wydruki
0
Wyświetlenia
810
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Something always irked me with how the cable from the extruder and bed would rub at certain positions. I figured it was primarily because Prusa designed the bed cable to go straight back, circle upwards, and then route down. Most of us have enclosures Prusa, please give us a 90-degree cable system for the bed! Anyway, for the bed, I made a 45-ish-degree routing system. This design also offers plenty of room inside the part for your cables, yet snug enough to hold the cables appropriately. I have printed a few from other makers that were way too snug. 

 

I also made a Buddy box mod to force the cable to enter the box perpendicularly (and at a 45-degree angle). This was primarily to force the cable down when the bed was to the rear. I specifically made this part so you do not have to un-cable anything. Simple zip ties are used to hold it in place underneath. 

 

Note: In my enclosure, it hits the back wall on VERY large prints. I did place a zip tie where the cable sleeve hits the wall to prevent erosion. 

Tagi