1 / 6
45 Degree Bed/45&90 Degree Buddy Box Cables Prusa MK3.5 MK3.9 MK4 for Enclosure — image 1
1 / 6

45 Degree Bed/45&90 Degree Buddy Box Cables Prusa MK3.5 MK3.9 MK4 for Enclosure

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

No pinch, not fret, bed cable re-routing. 45 (ish) degree bed cable routing for enclosure. 45 & 90 degree for Buddy box

Rating
0 / 5
Likes
15
Downloads
99
Makes
0
Views
812
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

Something always irked me with how the cable from the extruder and bed would rub at certain positions. I figured it was primarily because Prusa designed the bed cable to go straight back, circle upwards, and then route down. Most of us have enclosures Prusa, please give us a 90-degree cable system for the bed! Anyway, for the bed, I made a 45-ish-degree routing system. This design also offers plenty of room inside the part for your cables, yet snug enough to hold the cables appropriately. I have printed a few from other makers that were way too snug. 

 

I also made a Buddy box mod to force the cable to enter the box perpendicularly (and at a 45-degree angle). This was primarily to force the cable down when the bed was to the rear. I specifically made this part so you do not have to un-cable anything. Simple zip ties are used to hold it in place underneath. 

 

Note: In my enclosure, it hits the back wall on VERY large prints. I did place a zip tie where the cable sleeve hits the wall to prevent erosion. 

Tags