Creality K1 Filament Sensor Relocation Mount V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Relocates the filament runout sensor from the back of the machine to the right side
- Ocena
- 5 / 5
- Polubienia
- 67
- Pobrania
- 497
- Wydruki
- 1
- Wyświetlenia
- 4295
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Remix from Kraftwork47 (https://www.thingiverse.com/thing:6248552)
This mount relocates the filament runout sensor from the back of the machine to the right side. It offsets the sensor 45mm to line up with a feeder/dryer or side spool.
A new slot has to be cut into the top cover for the new Bowden tube's location. The connector for the sensor must be pulled through the back hole, a new hole made in the side panel, and then feed through to the new location.
There is enough service loop in the sensor cable to make it reach but be gentle pulling the excess through the feed hole to the board. I elected to drill two holes on the bottom of the mount for securement through the side panel but it's optional.
If you like my work, don't hesitate to support me by paying me a ☕. Thank you 🙂