1 / 5
Creality CR-10 V2 Stepping Motor to Direct Drive Conversion Mount — zdjęcie 1
1 / 5

Creality CR-10 V2 Stepping Motor to Direct Drive Conversion Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Creality CR-10 direct drive conversion mount for stepper motor.

Ocena
0 / 5
Polubienia
7
Pobrania
58
Wydruki
0
Wyświetlenia
252
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

I wanted a direct drive on my Creality CR-10v2 printer and didn't like the mounts I found on Thingiverse and other sites. I designed this mount using Fusion360 and printed in ABS, although I'm sure PLA would work fine. I simply used the stock stepping motor to create a low cost direct drive conversion. Since the CR-10 is a huge bed slinger, adding weight to the x-axis sled basically has no performance impact. So far, I've noticed no stringing and I was able to reduce the retraction distance from 5mm to 0.6mm. I did buy a new cable for the stepper motor since the stock wiring is too short.

Tagi