Bench stop Stanley workbench
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
How many of us have lost a bench stop from our Stanley workbench? They are hard to replace so I decided to print a few…
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 127
- Wydruki
- 1
- Wyświetlenia
- 464
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
How many of us have lost a bench stop from our Stanley workbench? They are hard to replace so I decided to print a few spares in PLA. I was concerned that the adhesion between layers of PLA is not very good so they might shear off if the vice is tightened too tightly. To get around this, I printed the model at 10 degrees off the horizontal. That means that if the shear force is horizontal, it will be distributed over a number of layers. It works well in practice.
Print Settings
Printer Brand:
Creality
Printer:
Ender 5
Rafts:
No
Supports:
Yes
Resolution:
0.4 mm
Infill:
100%
Filament: Multicomp PRO PLA works but PetG would be better Red is nice
Category: DIY