Templates - Dry Wall Cut Out - Low Voltage Single/Double/Triple Gang Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Templates for penciling a cut line for dry wall cut out for low voltage brackets
- Ocena
- 5 / 5
- Polubienia
- 23
- Pobrania
- 246
- Wydruki
- 2
- Wyświetlenia
- 713
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Public Domain
UPDATE Nov. 12, 2025 : Per the suggestion of “Troy” in the comments, I have added versions with notches (center marks) - these are the “02” version files.
UPDATE Nov. 14, 2025 : To make the “center mark” versions easier to use with a level, I added an addition modification - these are the “03” files with additional “bumps” added to enable a level to align easily..
Recently I was installing some Ethernet jacks, so I designed these templates to help with mounting the required low voltage brackets in dry wall.
CAUTION : I printed and tested only the single gang version of this print. The double and triple gang versions were designed based on CAD models of the corresponding brackets, but since I did have not any of these I did not make test prints.
These templates are designed to serve as a template for penciling a line on dry wall so that an opening can be cut out for a low voltage bracket. They have these features:
- The opening in the template corresponds to the hole size that needs to cut in the dry wall for the low voltage bracket.
- The outside outline of the template is the same size as the wall plate needed for the bracket.
- Each template has a “right-angle side” - this is intended to be used with a bubble level to level the template before tracing the inside opening with a pencil.
Use
- Position the template in the desired location for the bracket, while holding a bubble level against the right angle side (see photos).
- When the template is in the correct position (and level), use a pencil to trace the inside of the template on the dry wall.
- Use a drywall saw to cut an opening by cutting on the pencil line.
- Install the low voltage bracket.
Print Instructions
Print in PLA/PETG/FLEX using the 3mf files provided, otherwise :
- 0.2mm layer height
- 2 perimeters
- 15% rectilinear infill
CAD
The OnShape 3D CAD files for this are here :