Ryobi Glue Gun Skadis Offset Mounting Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed a slight offset on the trigger mount to mount the glue gun over the skadis board screws
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 62
- Wydruki
- 0
- Wyświetlenia
- 325
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to mount my glue gun by the screws since that area is mostly dead space, and it's hard to mount stuff there anyway. I found that I needed a bracket that was slightly offset compared to the old one (about 0.5mm), and the holes needed to be spaced further apart because I have two Skadis boards on top of one another.
Unlike the original, this print does need support material under the offset trigger hook.
It's a niche use case, but in case anyone needs it, I added the stl and Fusion 360 files. The F3D should be useful if you have trouble mounting the original where you want to.