Tronxy X5SA 8mm 525mm Linear Rod Mount with pocket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lower Rod mount for Tronxy rods, with pocket to make uppers flush.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 485
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The original mounts had the rod sticking out of the top mount by around 3mm, which caused collisions with the shoulder bolt nuts I used on my printed x-axis mounts. I put a pocket in the bottom mount so the tops sit flush in the printed uppers, giving the x-axis enough clearance to work properly. The rods fit tight in the pocket but hold it well once installed. Even if you don't have clearance issues, the uppers look better to me with them being flush anyway.
I used these from McMaster-Carr for the x-axis, and they're a bit longer than the suggested ones from AliExpress (but were available for delivery in 2 days instead of several weeks, the 92981A042 may also work, I have a set of those on the way to try also):
https://www.mcmaster.com/92981A050/
I used these for the front-mounted idlers also:
https://www.mcmaster.com/92981A038/
I also modified the x-axis mounts, getting rid of the pocket for the nuts, as the shoulder bolts I'm using were just a bit too long, and the threading on them wouldn't allow the pockets to work as intended (I'm using lock nuts on them now). These are not strictly necessary as you'll likely be using the correct length shoulder bolts, but I included them just in case you have slightly longer bolts like I do. The shorter length 92981A042's will most likely work perfectly fine with the original parts (I'll update here if they do fix the issue).