Logitech Extreme 3D Pro Desk mount bracket for Thrustmaster Desk Clamp, Bolt or Zip Tie on
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Don't want to spend 30-45 bucks for a desk mount to be able to use your Extreme 3D pro competently? This should help!
- Ocena
- 5 / 5
- Polubienia
- 87
- Pobrania
- 1146
- Wydruki
- 4
- Wyświetlenia
- 5084
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model is COMPLETE as of right now, everything fits as it should. I have played several hours of War Thunder and MFS, my thoughts are as follows:
The mounting bracket has a very still hold onto the ThrustMaster desk clamp especially given that it is using zip ties as mounting hardware.
V.2's mounting positioning is much more sturdy than V.1 so I would suggest printing that instead (It is also just slightly more visually pleasing as it does not overhang on the silly cutouts that logitech decided on. It also costs slightly less filament)
Overall very pleased with my mount and I hope that you will be too!!
Printed in Inland Mint Green PLA / Inland Blue Marble PLA
Ender3
.6mm nozzle
.20 Standard quality (I’m sure you could use draft and save yourself time)
10 percent gyroid infill
You will need good bed adhesion (I used some hairspray for insurance even if I have a textured PEI sheet)
Materials needed:
Zip Ties what I will be using since I know there is room for improvement or Access to hardware
Patience…
The mounting bracket is meant to be a TIGHT fit so that you don't pull it off the 3D Pro's base while pulling Top Gun maneuvers and or crashing into the ground.