maps Ender 3 and Ender 3 Pro Belt Tensioner Fat pack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fat pack with solutions i put on my Ender 3 and Ender 3 Pro remix for belt tensioning
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 72
- Wydruki
- 0
- Wyświetlenia
- 571
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Main positive points from this design:
- Fat pack with solutions
- more easier to assemble the belt with the tensioner mounted
- adapted for a roller GT2 20 with inner diameter of 3mm instead of the stock one.
- Still with the bushing for the stock roller
- belt's allways inside of the frame
- my pretty knob is included in this remix
BOM:
- 2 M3x20 screws
- 2 M3 Hexagonal nuts
- 1 Tnut for the X axis frame and screw
- 2 roller GT2 20 with inner diameter of 3mm (optional)
History:
For almost the beginning of my printing adventure i used the MakeChetti with good results, but it was always difficult to mount the belt with it in place.
Even with the tensioner the prints didn't had the quality that i liked to have and not like i saw on other makers videos. Then one day i found this Y belt mod and i printed and give is a try.
But when i try to mount it i broke the tensioner case because it was too tight to mount.
So i decided to remix it and make it stronger. I changed the Y case tansioner and the tensioner puller to have more space to mount the belt, and after reading the TeatchingTech article about the calibrating the step motors i had to install also a GT2 20 with inner diameter of 3mm to increase the quality.
i have included the X belt mod and one Y belt mod to ensure that the belt is always inside of the frame slot and not interfering with it. It's also a must have. The how to install them are on the links.
With all this modifications to my Ender 3 my print improved a lot.
Follow me for more designs and updates.
If you like my work, support and “buy me a criptocoffe"
Also, share some makes in here!
Updadte 2025.11.15
Now I have also an Ender 3 Pro. So i add a litle remix for the Y axis. Also a new version of the screw puller to work with a GT2 timing belt pulley.
Disclaimer:
You are a grown up, do it at your responsibility. If not, do it with parent supervision with their approval… hehehe
Good Luck and good prints