Voron 2.4 & Trident 350mm Canopy side handles

2.4 & Trident  350mmCanopy side handles

CHANGELOG:

•  30.03.2024: Initial release.

Description:

• I didn't want to remove the handles on my Trident when I started to print JSmith17's Canopy but didn't like the avalible options.
• I've been using the original “Sturdy Handles” before and they've done their job, so i saw JSB's X-Handle and started working on a way to add compatibility for those on the Canopy.

Pictures:

Printing:

Canopy sides:

• Default voron settings, correct orientation.
• You MUST add supports, I went for organic/three supports like this:

Front side

Back side

Result:

Handles:

• Default voron settings, correct orientation, no supprts needed!
• First load the handle itself to your slicer.
• Add "Infill.stl" as a modifier to the handle and adjust the infill properties of the modifier.(if you want to add other infill properties to the stress sones).
• Add "Fuzz.stl" as a modifier to the handle and enable fuzzy skin (contour) to the modifier (if you want to add texture to the handle).

If you've gone with both infill and fuzz you will end up with something like this:

This is the sliced view of mine when I use 40% Support Cubic infill on the handle, 40% 3D Honeycomb on the infill modifier & Countor fuzzy skin on the fuzz modifier:

BOM (per side):

Canopy sides:

• 2x M3x8 SHCS (I choose to use low profile ones)
• 2x M3 Roll-in T-nut

Handles:

•  4x M3x20mm SHCS (for the handle reinforcement)
• 2x M5x16mm  BHCS
• 2x M5 Roll-in T-nuts

To-do List:

•  Nothing that i can think of.

- - -

In case I forget to upload any eventual updates i make to the design to Printables, the latest released version should always be avalible on my gitub!