XR30 G6/G5 Ecotech Radion Light Shade
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Shades for Radion XR30 Gen 6/Gen 5, to minimize the light spill outside the tank.
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 553
- Wydruki
- 0
- Wyświetlenia
- 2366
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Remix of the remix by @percula
I liked this design with the angled sides, because this minimizes the lightloss. The thing I changed was that I wanted the back wall, for less light spill. Also I made it 5mm taller to further reduce the lightspill to where I sit. Then I made the wall of the angled part a bit smaller because this is not really necessary and reduces the (long) print time.
With Cura slicer this print would take over 20h, but with Orca Slicer I reduced the print time to 13h.
I also printed this in esun PLA+ because my previous lights (Redsea ReefLed160) had a shade with the same material for 2 years and never deformed.