XR30 G6/G5 Ecotech Radion Light Shade
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Shades for Radion XR30 Gen 6/Gen 5, to minimize the light spill outside the tank.
- Rating
- 5 / 5
- Likes
- 11
- Downloads
- 557
- Makes
- 0
- Views
- 2,375
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Remix of the remix by @percula
I liked this design with the angled sides, because this minimizes the lightloss. The thing I changed was that I wanted the back wall, for less light spill. Also I made it 5mm taller to further reduce the lightspill to where I sit. Then I made the wall of the angled part a bit smaller because this is not really necessary and reduces the (long) print time.
With Cura slicer this print would take over 20h, but with Orca Slicer I reduced the print time to 13h.
I also printed this in esun PLA+ because my previous lights (Redsea ReefLed160) had a shade with the same material for 2 years and never deformed.