1 / 3
K1/ K1C/ K1 Max Filament Feeder Assistant — zdjęcie 1
1 / 3

K1/ K1C/ K1 Max Filament Feeder Assistant

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

"One shot, one kill" when feeding your filament into the PTFE bowden tube with this feeder assistant.

Ocena
0 / 5
Polubienia
36
Pobrania
391
Wydruki
1
Wyświetlenia
1961
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I own a Creality K1C and feeding the filament into the PTFE bowden tube is a hit or miss depending on how awake or how much in a rush I am. Decided to take luck out of the equation by making this adaptor to “funnel” the filament into the PTFE bowden tube at the back.

It is a simple contraption that uses friction to hold on to the PTFE tube at the filament sensor end. On the other end is a 7.5mm (diameter) funnel to guide the filament into the 2.0mm opening of the PTFE bowden tube. That's 3.75 times wider and you should be less likely to fail.

I would recommend printing it in fine quality (0.12mm) due to the slight slope/ angle used for the friction hold.

Changelog

  • V2 - Changed to screw lock design for better grip on the bowden tube.
  • V1 - Initial release

How I printed it

  • Material: PLA
  • Layer height: 0.12mm
  • Pattern (top and bottom): Concentric
  • Walls: 3
  • Support: None
  • Raft/ Auto-brim: None

 

Tagi