5x5 spacer for Gridfinity to correct the OOPS
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you created SCAD parametrized Gridfinity boxes and run into the problem that they are too small for a box...
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 281
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
I used an SCAD parametrized model to create my Gridfinity boxes, using the default parameters.
It turned out that a height of 42mm without Z alignment (trhough e.g. Zack's method) does not lead to the correct height and as such I run into the problem that in my closed Gridfinity box washers and other things started to mix.
In order to prevent re-printing 25 boxes, I created this spacer which allows to be put into the Gridfinity box to compensate for the missing height.
Not sure how useful this is for others - but if you were running into the same problem: Here is the solution.