Modular tool holders, drawers and other little helpers

Modular tool holders, drawers and other little helpers for these tool sets:

• Inbus TORX T-Griff Schraubendreher Set 8tlg, TX9–40 → TORX screw drivers
• Inbus 70129 T-Griff Inbusschlüssel Set 8tlg, 2–10mm → Allen key screw drivers
• Wera Ratschenschraubendreher 816 RA, 1/4 Zoll x 142.0 mm → Ratchet screwdriver
• Wera 05022210001 950/9 Hex-Plus HF 1 Winkelschlüsselsatz → Allen key screw drivers
• Wera 05003474001 Kraftform Kompakt VDE 16 → Electrician screwdrivers as bits
• Wera Bit-Sortiment, Bit-Check 30 Metal 1, 30-teilig → Bit tool set 
• APTTOOL Abisolierzange → Wire stripper 
• FALLER Spezial-Seitenschneider → Side cutter 
• Holz-Gliedermaßstab 2M → Wooden folding rule 2 metres 
• Digitale Schieblehre 200 mm → Digital caliper 200m
• Digitale Schieblehre 150 mm → Digital caliper 150mm
• Radius gauges 1-35mm ;-)
• Inbus 74711 Inbusschlüssel Set 11tlg, 1.27–8mm, mit Kugelkopf → Allen keys *
• and some others… *

Notes: 

• Holders for the with * marked tools will follow soon. Just want to print them to be sure they fit the named and linked tools well too.
• More holders might be added over time…

Background:

• I really like working with GOOD tools and I think if you use scrap tools you can not deliver good results. That's why I use Prusa 3D printers only by the way…
• I use the above listed tools really often and they are really good mostly German quality tools which I use for years now. 
• I kept them in drawers until now, but I did not like the mess that they created all the time and that you often really need to search the just needed tool… So this should come to an end and I wanted to have my own sorting system that some kind is modular and simple to use and create… Gridfinity and such stationary solutions do not work for me because I want to be able to take the tools all at once to another room too.
• I wanted to see at a glance if the just needed tool is there and I want to take it out of its desired place all the time without searching.

Create custom holders:

• The chances that you might have the same tools might be small, so I want to share with you the basic form and sizes of the holdes, so you can easily create some yourself too.
• The most basic CAD file is available in the files as Fusion 360 file too:   =)

• The main part size of the top is 180x100mm:

• The side and height measurements are shown here:

Additional hardware needed:

• 1x M3x20 screw to mount the “pin” part to the “Wera screw driver holder“ part
• 4x optional rubber feet with up to Ø9mm on the bottom of each one of the holders  

Printing instructions:

• 0.3 draft profile
• Supports needed for the bigger cutouts in the “Wera screw driver holder“ only
• No brim needed
• Textured sheet used

Happy printing =)