IKEA Markus chair arm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are smaller arms for the Markus chair to enable it to fit easily under a desk, the final height is 160mm from…
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 117
- Wydruki
- 0
- Wyświetlenia
- 2153
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
These are smaller arms for the Markus chair to enable it to fit easily under a desk, the final height is 160mm from the bolt centreline. The design is loosely based on Hichi's but reduced to fit on a standard printer with a 250 mm x 200 mm bed. I have embedded the bolts fully in the rim to get better stiffness. The design is symmetrical and attaches using the standard bolts.
Print Settings
Printer Brand:
Prusa
Printer:
Mk2.5s
No
Supports:
Yes
0.35 mm
Infill:
80% around bolt holes
Filament:
Any PLA
Notes:
This needs to be pretty strong particularly around the bolt holes. This was printed with 5 perimeters at .35 layer height and 20% fill but i used the modification volume in PrusaSlicer to put 80% fill around the bolt holes. This worked fine and the arms feel as rigid as the steel ones.
Category: Office