Hager Network holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Network holder for Hager electrical fuse box. Holds 2 switches, one pihole and one router (could be 3rd switch).
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 799
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed to organize 2 switches, 1 router and 1 pihole in a very small space. Before adding the last switch it was all hanging unstable on standard Hager clamps. But there was no space for the 2nd switch, I created this holder to "stack" the equipment horizontal so it would fit all. I even included a cable canal in the back (L-shaped) so that the cable do not have to block the view.
Use 3.9mm by 13mm (minimal) self-tapping screws to secure the holder. 6 screws is enough, but you can go for all and you will need then at least 14 (including one for each middle section).