Lidded box for 6th gen VW Polo central tunnel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small box sized to fit the squared hole in the vw polo 6th series central tunnel, done mostly for places where…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 612
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
A small box sized to fit the squared hole in the vw polo 6th series central tunnel, done mostly for places where leaving exposed change in the car can cost a window.
The lid hinges on two couples of 1cm (diameter) by 1mm (thickness) magnets because i had a lot of those around and the hinges i printed in the past tended to wear out easily if used often.
I printed in pla and while writing this i'm not yet sure if it will tolerate well the summer heat inside the car or not.
5% infill is enough, it printed fine for me without supports.
Category: Other