Lidded box for 6th gen VW Polo central tunnel
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A small box sized to fit the squared hole in the vw polo 6th series central tunnel, done mostly for places where…
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 33
- Makes
- 0
- Views
- 612
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
A small box sized to fit the squared hole in the vw polo 6th series central tunnel, done mostly for places where leaving exposed change in the car can cost a window.
The lid hinges on two couples of 1cm (diameter) by 1mm (thickness) magnets because i had a lot of those around and the hinges i printed in the past tended to wear out easily if used often.
I printed in pla and while writing this i'm not yet sure if it will tolerate well the summer heat inside the car or not.
5% infill is enough, it printed fine for me without supports.
Category: Other