Silverline Drill Press Simple DRO mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple way to mount a Digital Vernier to my Silverline Drill press for a super cheap DRO
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 150
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Wanted to add a Digital Read Out to my drill press on the cheap, so bought the cheapest Digital Vernier I could find off Amazon, designed this clamp to fit around the Quill and fit the end of the vernier into (after a bit of surgery to remove the unneeded jaws and excess length).
The Vernier I used is this one.
https://www.amazon.co.uk/dp/B0947SKCYS?psc=1&ref_=cm_sw_r_cp_ud_ct_3Z8DX60S9JBV247VK8HE
It's all plastic, so very easy to chop down with a hacksaw.
The Quill Diameter is 40mm. - To mount the clamp all you will need a M4x10mm bolt and nut.
The body of the Vernier it attached to the front of the Drill press using the Masking tape and Superglue method currently. I may look to attach it more permanently later.