1 / 4
(Un)original Prusa Drybox Heat Cable Holder (Exo Terra 25W 4.5m) — zdjęcie 1
1 / 4

(Un)original Prusa Drybox Heat Cable Holder (Exo Terra 25W 4.5m)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Heat Cable Holder (Exo Terra 25W 4.5m) for (Un)original Prusa Drybox

Ocena
0 / 5
Polubienia
14
Pobrania
44
Wydruki
0
Wyświetlenia
998
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This is a heating cable holder (in my case an Exo Terra 25W 4.5m heating cable):
https://legacy.exo-terra.com/de/products/heat_cable.php

that with my optional additional mod
https://www.printables.com/de/model/785230-air-duct-prusa-enclosure-unoriginal-drybox
helps to keep the filaments dry in the (un)original drybox.


The holders are printed in 2 parts and put together - placed in the bottom of the drybox and the heating cable laid in serpentine lines.


2 optional variants: with or without cutouts for PTFE tubes.


The heating cable I use has 1.8m of the 4.5m "cold" connection cable, which can be led outside using a cable gland or similar.


The heat cable itself reaches approx. 50 degrees Celsius - I recommend using PETG or higher temperature-resistant material.


Of course, the whole thing can be done with a thermo/hygrostat like this one:

Elitech Plug-and-Play-Temperatur- und Luftfeuchtigkeitsregler – Elitech UK— ElitechEU

being controlled.

-----------------------------------------------------------------------------------------------------

dies ist ein heizkabelhalter (in meinem Fall ein Exo Terra 25W 4.5m Heizkabel):
https://legacy.exo-terra.com/de/products/heat_cable.php

Das mit meinem optional zusätzlichen Mod
https://www.printables.com/de/model/785230-air-duct-prusa-enclosure-unoriginal-drybox
dabei behilflich ist, die Filamente in der (un)original Drybox trocken zu halten.


Die Halter werden in 2 Teilen gedruckt und zusammengesteckt - in den Boden der Drybox gelegt und das Heizkabel darin in Schlangenlinien verlegt.


2 optionale Varianten: mit oder ohne Ausschnitte für PTFE Schläuche.


Bei dem Heizkabel das ich verwende sind 1,8m von den 4,5m "kaltes" Anschlußkabel, das mittels einer Kabelverschraubung oä nach aussen geführt werden kann.


Das Wärmekabel selbst erreicht ca. 50 Grad Celsius - ich empfehle PETG oder  höher Temperaturbeständiges Material zu verwenden.


Das ganze kann natürlich mit einem Thermo/Hygrostat wie diesem hier:

Elitech Plug-and-Play-Temperatur- und Luftfeuchtigkeitsregler – Elitech UK— ElitechEU

gesteuert werden.

 

Tagi