Heltec V2 and V3 Meshtastic Lora case: Fix for heat set inserts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Top section with added blocks to allow for use with M2 heat set inserts & screws.
- Ocena
- 0 / 5
- Polubienia
- 41
- Pobrania
- 234
- Wydruki
- 0
- Wyświetlenia
- 3192
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Added a few millimeters of blocking to screw holes so inserts don't fail to set (original model would tear through the sides). Still, you should be gentle screwing / unscrewing, as these are still very delicate.
I only recommend putting inserts in the 4 corners for the backplate. I have not tested the other 4 slots.
The antenna hole will fit perfectly with the standard heltec antenna connector, but it may not fit for after-market parts. Measure first if using aftermarket antenna connector.
Parts used:
- M2x8mm screws (Much too long, but they're the shortest I have)
- M2x3x3.2mm heat set inserts