Heltec V2 and V3 Meshtastic Lora case: Fix for heat set inserts
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Top section with added blocks to allow for use with M2 heat set inserts & screws.
- Rating
- 0 / 5
- Likes
- 41
- Downloads
- 235
- Makes
- 0
- Views
- 3,195
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Added a few millimeters of blocking to screw holes so inserts don't fail to set (original model would tear through the sides). Still, you should be gentle screwing / unscrewing, as these are still very delicate.
I only recommend putting inserts in the 4 corners for the backplate. I have not tested the other 4 slots.
The antenna hole will fit perfectly with the standard heltec antenna connector, but it may not fit for after-market parts. Measure first if using aftermarket antenna connector.
Parts used:
- M2x8mm screws (Much too long, but they're the shortest I have)
- M2x3x3.2mm heat set inserts