65mm wheel landing gear for Eclipson PITTS S12
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A landing gear for the Eclipson PITTS S12 that will take larger 65mm wheels, great for grass landings.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 140
- Wydruki
- 1
- Wyświetlenia
- 719
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- GNU General Public License v2.0
A landing gear for the Eclipson PITTS S12 that will take larger 65mm wheels. Useful for when you need to lands on grass.
- You need to mirror all parts in your slicer for the other side!
- Requires a 200mmx3mm rod for strength, just like the original
- The wheel axle requires 2mm rod
- Wheel width is 23mm
- Print the landing struts using eclipson profile C
- Rotate in your slicer to point the arrow up.
- Print the pants front/rear using eclipson profile A
- use 2 bottom layers for both front and rear
- use 5 top layers for the front
This comes in two versions, the standard version has a option to lock the 2mm wheel axle into place. You bend a 1cm section at 90deg. This is held in a groove by the wheel lock on the inside of the landing strut. You will require a M3 square nut, and a M3x8mm machine screw/bolt.
You can also load the f3d file in fusion, go to design > modify > “change parameters” and tweak the design yourself.
The version with “no lock” you will have to figure out how to fixate the wheel axle yourself, use 2.1mm collets or something.