1 / 2
SV06+ X Carriage Extruder Block for Drylin bearings — zdjęcie 1
1 / 2

SV06+ X Carriage Extruder Block for Drylin bearings

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

SV06+ X Carriage Extruder Block for Drylin bearings

Ocena
0 / 5
Polubienia
6
Pobrania
36
Wydruki
0
Wyświetlenia
347
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

SV06+ X Carriage Extruder Block for Drylin bearings

remixed off of the original sovol files for their injection molded parts

Added V2 which closes up the backside on the belt slit, which gives it a lot less possibility to warp

 

Instructions:

Make sure to verify the distance between your rods. Mine was 26.7mm inner measured from top of bottom rod to bottom of top rod (so not heart-to-heart). Normally it's 27, so you might need to add ~0.3mm spacing between the bearings for the top rod vs bottom rod.

Also bearing insert diameter might differ depending on your printer so that also might need some experimenting.

For me it took 4 tries to get it exactly right, both the rod-distance and the bearing opening diameter.

Tagi