Small Hands Spinner (625Z)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I designed this spinner for my 6 year old son since the standard configuration of 4 608ZZ bearings is too big for his…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 341
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial
I designed this spinner for my 6 year old son since the standard configuration of 4 608ZZ bearings is too big for his hands. The outer bearings are now 625Z bearings with a diameter of 16mm instead of 22mm.
To be clear, the center is still a 608 bearing as I've found that the smaller bearings don't spin nearly as well in this size of object.
I recommend using the knobs designed by CPME listed here:
https://www.thingiverse.com/thing:1979370
Print Settings
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 V2
No
Supports:
No
0.3
Infill:
10%
Notes:
These pop off at about 15 minutes apiece with my current settings, so you can hammer out 4 in an hour, easy.
Post-Printing
Hammers work, but I've been using channel lock pliers to squeeze the bearings in along the edge of a picnic table: one side of the pliers under the tabletop, one over the bearing.
How I Designed This
I used Fusion 360. Simple circular array with a little bit of filleting.
Category: Mechanical Toys