1 / 6
Magnetic Dishwasher CLEAN/DIRTY Toggle Label
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tired of inspecting coffee mugs for residue to decide if the dishwasher has been through a cycle or not? Print and track
- Ocena
- 0 / 5
- Polubienia
- 22
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 517
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (6)Wydruki i komentarze (Wydruki: 0) (Komentarze: 4)Remiksy (0)Kolekcje (25)Powiązane
UPDATE: Now with recesses for magnets in the slider for magnetic latching!
You will need:
- 4x 10x1.5mm disc magnets (OPTIONAL: +2 for the slider latch)
- Ideally, 3 colours of filament
My print settings:
- Infill: 15%
- Layer Height: 0.15mm
- Nozzle Diameter: 0.6mm
- Printer: Prusa mk4
Notes:
- I used a 0.2mm tolerance around the magnet recesses, but depending on your printer, you might need to change these if too tight/loose.
- Fusion 360 file is (partially) parametric if you have different magnets available
Construction:
- Insert the 4 magnets. I recommend using a whole stack of magnets to press-fit them in and then slide the whole stack off to the side. If necessary, glue but be warned! CA glue fumes will cloud your pretty print! A dab of liquid nails would do the trick.
- Insert DIRTY and CLEAN labels. These should press-fit in.
- UPDATE: Insert magnets into the slider part, making sure the polarity matches those earlier
- Snap the slider over the whole assembly
Opportunities:
- Additional magnets to latch the slide in place → UPDATE: New part included!
- Blank Blocks for customisation → UPDATE: New parts included!