1 / 3
TUSH one piece - Multi-spool (printed rims and axles) — zdjęcie 1
1 / 3

TUSH one piece - Multi-spool (printed rims and axles)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Double-wide spool holder to allow multiple spools sitting close together.

Ocena
0 / 5
Polubienia
6
Pobrania
17
Wydruki
0
Wyświetlenia
206
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial

I wanted to be able to create a dry box that could hold multiple spools and dispense from them at the same time. The legs on the original left a lot of space between spools when placed side by side. I designed this to reduce the waste space when storing multiple spools side by side. It is meant to be used with one of the original single axle model on each side.

I printed in PLA, but you may want to print in something stronger and more heat resistant. If you have trouble getting the parts together, scale the axles down if they are hard to get into the bearing, scale the body up if the axles don't fit the body but do fit the bearing, and scale rims up if the bearings are hard to insert. One or two percent should be all you need.

I used the absolute cheapest 608ZZ bearings I could find on Amazon. Quality of the bearings isn't an issue, since they will never take the abuse they would on a skateboard.

Tree supports recommended on the body for the axle holes. You may also want to ream them out with a 5/16" drill bit.

Tagi