1 / 1
Makita B03050 Sander 35mm Vacuum Hose Adaptor — zdjęcie 1

Makita B03050 Sander 35mm Vacuum Hose Adaptor

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a hose adaptor designed to fit a Makita B03050 Sander to a 35mm OD Vacuum Hose

Ocena
0 / 5
Polubienia
5
Pobrania
65
Wydruki
0
Wyświetlenia
333
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution

A Makita 03050 Orbital Sander is commonly used for sanding of many things and it can produce a lot of dust which can be injurious to health and make a big mess. The solution is to attach a vacuum by way of a hose to collect the dust for safe disposal. The 21mm vacuum pipe on the sander is smaller than some of the rubber pipes used by vacuum cleaners.  An adaptor like this model is used to match the vacuum pipe to the sander.

I found other similar models on Thingiverse for this same requirement, but they were not of a suitable size for my particular requirement.  I modelled this version from scratch to further my expertise in F360.  It took 20 minutes. My design was based on a real physical example that was broken, and so required improvement.

This adaptor suits the 23 - 21 mm tapered connection on the sander (fits inside the adaptor), to a 35 mm outside diameter rubber vacuum tube (also fits inside the adaptor). The adaptor is designed with 2.5 mm walls, and has an offset and a brace. The Brace adds strength, as it was found to break in the area where the diameter changes.

The ideal material recommended for this project on other models is Flex TPU, I used shore 98A. But I found that the TPU 98A that I have produced variable wall thickness and weakness, poor layer adhesion.  So, I next tried Polymaker CoPA instead, which turn out to be too hard. Nylon is quite hard and only slightly flexible, and it will not stretch at all. Finally tried Polypropylene material which comes out the best. Its quite a lot of trouble to print, requiring tape and glue to be applied to the bed plate, but the material is strong. and more flexible than PA, and prints with a smooth surface having zero defects.  I have since discovered that Magigoo PP can be used on a sating plate to print PP, and it works well.

The hose needs to bend when a little used, but have a tight fit, so a little stretch is needed too.  
Printing Guidance: 
1. Tested on a Prusa Mk4 printer fitted with 0.4 mm brass nozzle and Silicone Sock.
2. Enclosure: es (might work without it)
3. Supports : None
4. Infill: 25%  Triangles
5. Brim: 5 mm
6. Print Profile: 0.2 Structural. 
6a. 45 mm/s perimeter speed
7. Print Bed: Prusa Smooth Plate with applied PP tape and Korex glue
8. Filament: Generic PP filament from 3DEA Auckland NZ
9. Extrusion Multiplier carefully tuned.
10. Extruder Idler screw backed off 180 degrees from standard.
 
 

Tagi