Frsky X12S "Eye of Horus" Roller Button
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I didn't care for the factory roller button on the Frsky X12S Transmitter so decided to have a little fun…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 556
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I didn't care for the factory roller button on the Frsky X12S Transmitter so decided to have a little fun designing/printing a replacement.
Now my Horus has a proper eye.
Print instructions
Category: R/C Vehicles Print Settings
Printer: Original Prusa i3 MK2
Rafts: Yes
Supports: Yes
Resolution: 0.2mm
Infill: 100%
Notes:
I used Simplify3D to slice this and printed with full raft and custom supports to keep the bottom of the button clean. I ended up using two different processes, one for the button body and then one with a narrower extrusion width and higher infill overlap for the eye detail as Simplify3D would only print the outlines with no infill using my standard settings.
I also adjusted the inner diameter of the hole and flat for the switch shaft to work best with my slicer and printer. It took a couple of iterations to get right and may need further adjustment depending on which slicer and/or printer you use. I included a step file along with the stl to hopefully make that easier.